Adding User-defined Information to Commands

Certain commands permit adding to the list of available values for certain parameters (for example, the Material list for the Spring Calculator or the Units list for the Simple Beam command).

Parameters Allowing Addition of User-defined Values in the GetUserData.vss File
Group	Plug-in Object	Parameter	Dialog Box
1	Spring Calculator	Units (inches, mm and cm only)	Spring Calculator
	Shaft Analysis	Outside Diameter	Shaft Analysis
	Simple Beam	Beam Length	Simple Beam: Set Beam Properties
	Simple Beam	Deflection Units	Simple Beam: Set Beam Properties
2	Simple Beam	These items are the singular form of the names in Group 1 and are used when writing the values to a worksheet and a text block on the drawing	Not applicable
3	Simple Beam	Load Units	Simple Beam: Add/Remove/Change Loads
4	Simple Beam	These items are the singular form of the names in Group 3 and are used when writing the values to a worksheet and a text block on the drawing	Not applicable
5	Simple Beam	Section Modulus Units	Simple Beam: Set Beam Properties
6	Simple Beam	Moment of Inertia Units	Simple Beam: Set Beam Properties
7	Shaft Analysis	Shear Modulus Units	Shaft Analysis
	Simple Beam	Modulus of Elasticity Units	Simple Beam: Set Beam Properties
8	Spring Calculator	Material	Spring Calculator
9	Shaft Analysis	Twisting Moment Units	Shaft Analysis